CRXUSA.Com

Workshop Repair Manual

Honda Fit/Jazz - A/C Evaporator Core Replacement

A/C Evaporator Core Replacement

NOTE: LHD type is shown, RHD type is symmetrical.

Recover the refrigerant with a recovery/recycling/charging station.

2.

Cut the joint caps (A) and thoroughly clean around the joints of dirt and debris by pressurized air or detergent. Remove the stops (B), then disconnect the receiver line (C) and the suction line (D). Clean inside wall of the joints of dirt and debris using a refrigerant oil (KEIHIN SP-10) applied swab. Do not use compressed air or detergent after disconnecting the joints. Plug or cap the lines immediately after disconnecting them to avoid moisture and dust contamination.

Remove the blower unit.

4.	Remove the self-tapping screws and the pipe cover (A), then remove the bolts, the inlet and outlet pipes (B), and the expansion valve (C).

5.	Disconnect the connector (A) from the evaporator temperature sensor, then remove the connector clip (B). Remove the self-tapping screws and the duct (C).

6.	Pull out the evaporator core (A) with the plate (B).

Charge the system.

Honda Fit/Jazz 02-05 Workshop Manual    Back to all Manuals