Honda Fit/Jazz - ABS Modulator-Control Unit Removal and Installation (Without VSA)
ABS Modulator-Control Unit Removal and Installation
NOTE:
- Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water.
- Take care not to damage or deform the brake lines during removal and installation.
- To prevent the brake fluid from flowing, plug and cover the hose ends and joints with a shop towel or equivalent material.
Removal
1. | Pull up the lock (A) of the ABS control unit 25P connector (B), and the connector disconnects itself.
|
2. | Disconnect the six brake lines.
|
3. | Remove the two 6 mm nuts.
|
4. | Remove the ABS modulator-control unit (C).
|
Installation
1. | Install the ABS modulator-control unit, then tighten the two 6 mm nuts.
|
2. | Reconnect the six brake lines, then tighten the nuts.
|
3. | Align the connecting surface of the ABS control unit 25P connector.
|
4. | Push in the lock of the ABS control unit 25P connector until you hear it click into place, then connect the connector.
|
Bleed the brake system, starting with the front wheels.
6. | Start the engine, and check that the ABS indicator goes off.
|
7. | Test-drive the vehicle, and check that the ABS indicator does not come on.
|
Honda Fit/Jazz 02-05 Workshop Manual
Back to all Manuals