Honda Fit/Jazz - CVT Driven Pulley Shaft Bearing Removal/Installation (CVT)
CVT Driven Pulley Shaft Bearing Removal/Installation
Special Tools Required
Snap ring pliers( 07LGC-0010100)
Handle driver( 07749-0010000)
Oil seal driver attachment, 64 x 72 mm( 07JAD-PN00100)
1. | Expand the snap ring of the driven pulley shaft bearing with the snap ring pliers, then remove the driven pulley shaft bearing with the special tools and a press.
|
2. | Expand the snap ring of the driven pulley shaft bearing with the snap ring pliers, then install the bearing part-way into the housing.
|
3. | Release the pliers, then push the bearing down into the housing until the snap ring snaps in place around it.
|
4. | After installing the bearing, verify that the snap ring are seated in the bearing and housing grooves, and that the ring and gap is 0-9 mm (0-0.35 in.)
|
Honda Fit/Jazz 02-05 Workshop Manual
Back to all Manuals