Honda Fit/Jazz - Coolant Replacement (L12A/L13A)
Coolant Replacement
1. | Start the engine. Set the heater temperature control dial to maximum heat, then turn off the ignition switch. Make sure the engine and radiator are cool to the touch.
|
2. | Remove the radiator cap.
|
3. | Loosen the drain plug (A), and drain the coolant.
|
4. | Remove the drain bolt (A) from the front side of the cylinder block.
|
5. | After the coolant has drained, reinstall the drain bolt with a new washer.
|
6. | Tighten the radiator drain plug securely.
|
7. | Fill the reserve tank to the MAX mark (A) with genuine Honda All Season Antifreeze/Coolant Type 2.
|
8. | Pour genuine Honda All Season Antifreeze/Coolant Type 2 into the radiator up to the base of the filler neck.
NOTE:
- Always use genuine Honda All Season Antifreeze/Coolant Type 2. Using a non-Honda coolant can result in corrosion, causing the cooling system to malfunction or fall.
- Genuine Honda All Season Antifreeze/Coolant Type 2 is a mixture of 50 % antifreeze and 50 % water. Pre-mixing is not required.
Engine Coolant Refill Capacity including the reserve tank capacity of 0.4 liter (0.4 US qt, 0.4 lmp qt):3.6 liter (3.8 US qt, 3.2 Imp qt) | |
9. | Install the radiator cap loosely.
|
10. | Start the engine and let it run until it warms up (the radiator fan comes on at least twice).
|
11. | Turn off the engine. Check the level in the radiator and add genuine Honda All Season Antifreeze/Coolant Type 2 if needed.
|
12. | Put the radiator cap on tightly, then run the engine again and check for leaks.
|
Honda Fit/Jazz 02-05 Workshop Manual
Back to all Manuals