Honda Fit/Jazz - DTC Troubleshooting: 13-3
Chrysler Automotive Service ManualsHigh Quality Online manuals, fast download
DTC Troubleshooting: 13-3
| DTC 13-3: | No Signal from the Driver's Side Impact Sensor |
Special Tools Required
SRS inflator simulator( 07SAZ-TB4011A)
Erase the DTC memory.
| 2. | Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off. Does the SRS indicator stay on? YES - Go to Go to Troubleshooting Intermittent Failures. |
| 3. | Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes. |
| 4. | Check the connection between the IDi connector and the driver's side impact sensor. Is the connection OK? YES - Go to 5. NO - Replace the driver's side impact sensor.n |
| 5. | Disconnect the TL1o and TR1o connectors (A) from the TL1i and TR1i connectors (B).  |
| 6. | Disconnect the IDi connector (A) from the driver's side impact sensor.  |
| 7. | Connect the special tool (jumper connector) to the IDi connector (A). |
| 8. | Disconnect the U2o connector (A) from the SRS unit.  |
| 9. | Check resistance between the No. 19 and No. 20 terminals of U2o connector. There should be 1.0 W or less.  Is the resistance as specified? YES - Faulty driver's side impact sensor or SRS unit; replace the SRS unit.n NO - Open or increased resistance in the floor wire harness; replace the floor wire harness.n |
Chrysler Automotive Service ManualsHigh Quality Online manuals, fast download
