Honda Fit/Jazz - DTC Troubleshooting: P0113 (10) (With ETCS)
DTC Troubleshooting: P0113 (10)
DTC P0113: | IAT Sensor Circuit High Voltage |
1. | Turn the ignition switch ON (II). |
2. | Check the IAT SENSOR in the DATA LIST with the HDS. Is about -45°C (-49°F) or less, or 4.49 V or higher indicated? YES - Go to Connect the ECM test harness and the test pin box between the ECM and connector. |
14. | Measure voltage between test pin box terminal No. 80 and body ground. Is there about 5 V? YES - Repair open in the wire between the ECM connector No. 3 terminal No. 51 (test pin box terminal No. 80) and the IAT sensor, then go to Do the ETCS learn procedure. |
21. | Check for Temporary DTCs or DTCs in the DTCs MENU with the HDS. Are any Temporary DTCs or DTCs indicated? YES - If DTC P0113 is indicated, check for poor connections or loose terminals at the IAT sensor and the ECM, then go to Substitute a known-good ECM. |
23. | Check for Temporary DTCs or DTCs in the DTCs MENU with the HDS. Are any Temporary DTCs or DTCs indicated? YES - If DTC P0113 is indicated, check for poor connections or loose terminals at the IAT sensor and the ECM, then go to Replace the original ECM.n |