Honda Fit/Jazz - DTC Troubleshooting: P0342 (9) (With ETCS)
Documents and Books Scanning ServiceBest Prices! Fast fulfillment, OCR Included
DTC Troubleshooting: P0342 (9)
DTC P0342: | CMP Sensor Circuit Low Voltage |
1. | Turn the ignition switch ON (II). |
2. | Do the DTC CLEAR in the CLEAR MENU with the HDS. |
3. | Start the engine. If the engine does not start, keep cranking for 10 seconds. |
4. | Check for Temporary DTCs or DTCs in the DTCs MENU with the HDS. Is DTC P0342 indicated? YES - Go to Connect the ECM test harness and the test pin box to the wire harness only, not to the ECM. |
12. | Check for continuity between test pin box terminals No. 35 and body ground. Is there continuity? YES - Repair short in the wire between the ECM connector No. 3 terminal No. 6 (test pin box terminal No. 35) and the CMP sensor, then go to Do the ETCS learn procedure. |
19. | Start the engine, and wait 10 seconds. |
20. | Check for Temporary DTCs or DTCs in the DTCs MENU with the HDS. Are any Temporary DTCs or DTCs indicated? YES - If DTC P0342 is indicated, check for poor connections or loose terminals at the CMP sensor and the ECM, then go to Substitute a known-good ECM. |
22. | Start the engine. |
23. | Check for Temporary DTCs or DTCs in the DTCs MENU with the HDS. Are any Temporary DTCs or DTCs indicated? YES - If DTC P0342 is indicated, check for poor connections or loose terminals at the CMP sensor and the ECM, then go to Replace the original ECM.n |
Documents and Books Scanning ServiceBest Prices! Fast fulfillment, OCR Included