Honda Fit/Jazz - DTC Troubleshooting: P0562 (34), P0563 (34) (With ETCS)
DTC Troubleshooting: P0562 (34), P0563 (34)
DTC P0562: | ECM Power Source Circuit Low Voltage |
| |
| |
1. | Turn the ignition switch ON (II).
|
2. | Clear the DTC with the HDS.
|
3. | Start the engine. Hold the engine speed at 3,000 rpm (min-1) without load (in neutral) until the radiator fan comes on, then let it idle.
|
4. | Test-drive the vehicle for about 5 minutes. Try to keep the vehicle speed at the 50 km/h (31 mph).
|
5. | Check for Temporary DTCs or DTCs in the DTCs MENU with the HDS.
Is DTC P0562 and/or P0563 indicated?
YES - Go to Connect the ECM test harness and the test pin box between the ECM and connector.
|
16. | Measure voltage between body ground and the test pin box terminals No. 128 and No. 129 individually.
Is there battery voltage?
YES - Go to Do the ETCS learn procedure.
|
22. | Start the engine. Hold the engine speed at 3,000 rpm (min-1) without load (in neutral) until the radiator fan comes on, then let it idle.
|
23. | Test-drive the vehicle for about 5 minutes. Try to keep the vehicle speed at the 50 km/h (31 mph).
|
24. | Check for Temporary DTCs or DTCs in the DTCs MENU with the HDS.
Is DTC P0562 and/or P0563 indicated?
YES - If DTC P0562 and/or P0563 is indicated, check for poor connections or loose terminals at PGM-FI main relay 1 and the ECM, then go to Substitute a known-good ECM.
|
26. | Start the engine. Hold the engine speed at 3,000 rpm (min-1) without load (in neutral) until the radiator fan comes on, then let it idle.
|
27. | Test-drive the vehicle for about 5 minutes. Try to keep the vehicle speed at the 50 km/h (31 mph).
|
28. | Check for Temporary DTCs or DTCs in the DTCs MENU with the HDS.
Are any Temporary DTCs or DTCs indicated?
YES - If DTC P0562 and/or P0563 is indicated, check for poor connections or loose terminals at PGM-FI main relay 1 and the ECM, then go to Replace the original ECM.n |
Honda Fit/Jazz 02-05 Workshop Manual
Back to all Manuals