Honda Fit/Jazz - Driver's Airbag Replacement
Driver's Airbag Replacement
Removal
| 1. | Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
|
| 2. | Remove the access panel (A) from the steering wheel, then disconnect the connector between the cable reel 4P connector (B) and driver's airbag 4P connector (C).
 |
| 3. | Remove the two Torx bolts (A) using a Torx T30 bit. Then remove the driver's airbag (B).
 |
Installation
| 1. | Place the new driver's airbag (A) in the steering wheel, and secure it with new Torx bolts (B).
 |
| 2. | Connect the cable reel 4P connector (A) to the driver's airbag 4P connector (B), then install the access panel (C) on the steering wheel.
 |
| 3. | Connect the battery negative cable.
|
| 4. | After installing the airbag, confirm proper system operation:
- Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
- Make sure the horn button works.
|
Honda Fit/Jazz 02-05 Workshop Manual
Back to all Manuals
