CRXUSA.Com

Workshop Repair Manual

Honda Fit/Jazz - ECM/PCM Idle Learn Procedure (L12A/L13A 5MT)

ECM/PCM Idle Learn Procedure

The idle learn procedure must be done so that the ECM/PCM can learn the engine idle characteristics.
Do the idle learn procedure whenever you do any of these actions:

• Disconnect the battery.
  
• Replace the ECM/PCM or disconnect its connector.
  
• Reset the ECM/PCM.
  
  NOTE: Erasing DTCs with HDS does require the idle learn procedure to be done again.
  
• 
  
• Remove the No. 20 (15A) fuse from the under-dash fuse/relay box.
  
• Remove the No. 1 (80A) and No. 6 (40A) fuses from the under-hood fuse/relay box.
  
• Remove the PGM-FI main relay.
  
• Remove the battery wire from the under-hood fuse/relay box.
  
• Disconnect any of the connectors from the under-hood fuse/relay box.
  
• Disconnect the G1 terminal from the transmission housing.
  
• Adjust the idle speed.
  

Procedure:
To complete the idle learn procedure do this:

1.	Make sure all electrical items (A/C, audio, rear defogger, lights, etc.) are turned off.

2.	Start the engine. Hold the engine speed at 3,000 rpm with no load (in Park or neutral) until the radiator fan comes on, or the engine coolant temperature reaches 80°C (176°F) -100°C (221°F).

3.	Let the engine idle for about 5 minutes with the throttle fully closed and with all electrical items off. NOTE: If the radiator fan comes on during this step, the time when it is operating must not be included in the 5 minutes.

Honda Fit/Jazz 02-05 Workshop Manual    Back to all Manuals