Honda Fit/Jazz - Engine Oil Pan Installation
Engine Oil Pan Installation
1. | Remove old liquid gasket from the oil pan mating surfaces, bolts and bolt holes.
|
2. | Clean and dry the oil pan mating surfaces.
|
3. | Install the new oil pan gasket on the oil pan.
|
4. | Apply liquid gasket, P/N 08C70-K0334M or 08C70- X0331S, to the cylinder block mating surface of the oil pan and the inner threads of the holes.
NOTE:- Apply a 1.5 mm wide bead of the liquid gasket along the broken line (A).
- Apply a 5.0 mm wide bead of the liquid gasket to the shaded area (B).
- Do not install the parts if 5 minutes or more have elapsed since applying liquid gasket. Instead, reapply liquid gasket after removing old residue.
|
5. | Install the oil pan (A) with dowel pin (B) and new O-ring (C).
|
6. | Tighten the bolts in two or three steps.
Specified torque:(1): | 24 N·m (2.4 kgf·m, 17 lbf·ft) | (2)-(13): | 12 N·m (1.2 kgf·m, 8.7 lbf·ft) | |
7. | Install the clutch cover/torque converter cover (A), and tighten the two bolts (B) securing the transmission.
|
8. | Install the dipstick tube (A) with new O-ring (B).
|
9. | After assembly, wait at least 30 minutes before filling the engine with oil.
|
Honda Fit/Jazz 02-05 Workshop Manual
Back to all Manuals