Honda Fit/Jazz - Fuel Line/Quick-Connect Fittings Installation (Without ETCS)
Place your banner in PDF ManualTry if FREE Today!
Fuel Line/Quick-Connect Fittings Installation
1. | Check the contact area (A) of the pipe (B) for dirt and damage, and clean if necessary. |
3. | Before connecting a new fuel tube/quick-connect fitting assembly (A), remove the old retainer (B) from the mating pipe. |
4. | Align the quick-connect fittings with the pipe (A), and align the retainer (B) locking pawls with the connector (C) grooves. Then press the quick-connect fittings onto the pipe until both retainer pawls lock with a clicking sound. NOTE: If it is hard to connect, put a small amount of new engine oil on the pipe end. Connection with new retainer: Reconnection to existing retainer: |
5. | Make sure the connection is secure and that the pawls are firmly locked into place; check visually and by pulling the connector. |
6. | Reconnect the negative cable to the battery, and turn the ignition switch ON (II). The fuel pump will run for about 2 seconds, and fuel pressure will rise. Repeat 2 or 3 times, and check that there is no leakage in the fuel supply system. |
Place your banner in PDF ManualTry if FREE Today!