Honda Fit/Jazz - Fuel Pump/Fuel Gauge Sending Unit Replacement (With ETCS)
Fuel Pump/Fuel Gauge Sending Unit Replacement
Special Tools Required
Fuel sender wrench( 07XAA-001010A)
Relieve the fuel pressure.
2. | Remove the fuel fill cap.
|
Remove the center console, and remove the parking brake lever (A).
4. | Remove the access panel (A) from the floor.
|
5. | Disconnect the fuel pump 5P connector (B).
|
6. | Disconnect the quick-connect fitting (C) and hoses (D) from the fuel tank unit.
|
7. | Using the tool, loosen the fuel tank unit locknut (A).
|
8. | Remove the locknut (A) and the fuel tank unit.
|
9. | Remove the strainer case (B), the fuel gauge sending unit (C), the case (D), the wire harness (E), and the fuel pressure regulator (F).
|
10. | When connecting the fuel tank unit, make sure the connection is secure and the suction filter (G) is firmly connected to the fuel pump (H).
|
11. | Install the part in the reverse order of removal with a new base gasket (I) and new O-rings (J), then check these items:
- When connecting the wire harness, make sure the connection is secure and the connector (K) is firmly locked into the place.
- When installing the fuel gauge sending unit, make sure the connection is secure and the connector is firmly locked into place. Be careful not to bend or twist it excessively.
- When installing the fuel tank unit align, the marks (L) on the fuel tank (M) and the fuel tank unit (N).
|
Honda Fit/Jazz 02-05 Workshop Manual
Back to all Manuals