Honda Fit/Jazz - Idle Speed Inspection - L13A6 (CVT)
Idle Speed Inspection - L13A6
L13A6 engine
NOTE:
- Leave the idle air control (IAC) valve connected.
- Before checking the idle speed, check these items:
- The malfunction indicator lamp (MIL) has not been reported on.
1. | Disconnect the evaporative emission (EVAP) canister purge valve 2P connector.
|
2. | Connect a tachometer (A) to the test tachometer connector (B), or connect the HDS or a scan tool to the data link connector (DLC) (C) located under the driver's side of the dashboard.
|
3. | Start the engine. Hold the engine speed at 3,000 rpm (min-1) without load (in Park or neutral) until the radiator fan comes on, then let it idle.
|
4. | Check the idle speed without load conditions: headlights, blower fan, rear defogger, radiator fan, and air conditioner are not operating.
Idle speed should be: | | 700±50 rpm (min-1) (in Park or neutral) |
|
5. | Idle the engine for 1 minute with A/C switch ON, temperature control at maximum cool, blower fan at maximum speed, rear window defogger ON,headlights at high beam, then check the idle speed.
Idle speed should be: | | 850±50 rpm (min-1) (in Park or neutral) |
NOTE: If the idle speed is not within specification, do the symptom troubleshooting.
|
6. | Reconnect the EVAP canister purge valve 2P connector.
NOTE: You can use the HDS or a scan tool to inspect idle speed.
|
Honda Fit/Jazz 02-05 Workshop Manual
Back to all Manuals