Honda Fit/Jazz - Imoes Unit Input Test (Except KH)
Imoes Unit Input Test
2. | Disconnect the 5P connector (A) from the imoes unit (B).
|
3. | Inspect the connector and socket terminals to be sure they are all making good contact.
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system. If the terminals look OK, make the following input tests at the connector.
- If a test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, the Imoes unit must be faulty; replace it.
Cavity | Wire | Test condition | Test: Desired result | Possible cause if result is not obtained |
---|
3 | YEL | Ignition switch ON (II) | Check for voltage to ground: There should be battery voltage. | - Blown No. 3 (7.5 A) fuse in the under-dash fuse/relay box
- An open in the wire
| 5 | WHT/RED | Under all condition | Check for voltage to ground: There should be battery voltage. | - Blown No. 8 (15 A) fuse in the under-hood fuse/relay box
- An open in the wire
| 1 | BRN/YEL | Under all condition | Check for continuity to ground: There should be continuity. | - Poor ground (G101)
- Faulty ECM/PCM or disconnect ECM/PCM connector
- An open in the wire
| 2 | RED/BLU | Ignition switch ON (II) | Check for continuity to ground: There should be battery voltage. | - Faulty immobilizer control unit-receiver
- unit-receiver
- Faulty ECM/PCM
- An open in the wire
| 4 | BLU/RED | Ignition key removed from the ignition switch | Check for continuity to ground: There should be continuity. There should be battery voltage. | - Faulty gauge assembly
- An open in the wire
|
|
Honda Fit/Jazz 02-05 Workshop Manual
Back to all Manuals