Honda Fit/Jazz - Injector Replacement (With ETCS)
Injector Replacement
Remove the intake manifold.
4. | Disconnect the connectors from the injectors (A), and remove the harness clip (B) from the fuel rail (C).
|
5. | Disconnect the quick-connect fittings (D).
|
6. | Remove the fuel rail bracket (E).
|
7. | Remove the fuel rail mounting nuts (F) from the fuel rail.
|
8. | Remove the injector clip (G) from the injector.
|
9. | Remove the injector from the fuel rail.
|
10. | Coat the new O-rings (A) with clean engine oil, and insert the injectors (B) into the fuel rail (C).
|
11. | Install the injector clip (D).
|
12. | Coat the injector O-ring (E) with clean engine oil.
|
13. | To prevent damage to the O-rings, install the injectors in the fuel rail first, then install them in the injector base (F).
|
14. | Install the fuel rail mounting nuts. Install the fuel rail bracket (G).
|
15. | Connect the quick-connect fittings.
|
16. | Connect the connectors on the injectors, and install the harness clip (H).
|
Install the intake manifold.
19. | Turn the ignition switch ON (II), but do not operate the starter. After the fuel pump runs for about 2 seconds, the fuel pressure in the fuel line rises. Repeat this 2 or 3 times, then check for fuel leakage.
|
Honda Fit/Jazz 02-05 Workshop Manual
Back to all Manuals