Honda Fit/Jazz - Keyless Receiver Unit Input Test
Keyless Receiver Unit Input Test
Remove the driver's dashboard under cover.
Remove the mounting nuts and down the under-dash fuse/relay box.
| 3. | Disconnect the 5P connector (A) from the keyless receiver unit (B).
 |
| 4. | Inspect the connector and socket terminals to be sure they are all making good contact.
- If the terminal are bent, loose or corroded, repair them as necessary, and recheck the system.
- If the terminals are OK, go to 5.
|
| 5. | With the connector still disconnected, make these input test at the connector.
- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, replace the keyless receiver unit.
| Cavity | Wire | Test condition | Test: Desired result | Possible cause if result is not obtained |
|---|
| 1 | BLK | Under all conditions | Check for continuity to ground: There should be continuity. | - Poor ground (G402)
- An open in the wire
| | 3 | YEL | Ignition switch ON (II) | Check for voltage to ground: There should be battery voltage. | - Blown No. 28 (20 A) fuse in the under-dash fuse/relay box
- An open in the wire
| | 5 | WHT/RED | Under all conditions | Check for voltage to ground: There should be battery voltage. | - Blown No. 8 (15 A) fuse in the under-hood fuse/relay box
- An open in the wire
| | 2 | BLU/ORN | Under all conditions | Check for continuity between the No. 2 terminal and the C 12 terminal of the gauge assembly connector C (30 P). There should be continuity. | |
|
Honda Fit/Jazz 02-05 Workshop Manual
Back to all Manuals
