Honda Fit/Jazz - M/T Differential Thrust Clearance Adjustment (L12A/L13A 5MT)
M/T Differential Thrust Clearance Adjustment
Special Tool Required
Driver, 40 mm I.D.( 07746-0030100)
1. | Install the 72 mm shim (A) that's the same size as the one you removed.
|
2. | Install the differential assembly (A) into the clutch housing.
|
3. | Install the transmission housing onto the clutch housing, then tighten the 8 mm flange bolts in a crisscross pattern in several steps.
8 x 1.25 mm | 27 N·m (2.8 kgf·m, 20 Ibf·ft) |
|
4. | Use the special tool to bottom the differential assembly in the clutch housing.
|
5. | Measure clearance between 72 mm shim and bearing outer race in transmission housing.
Standard: | 0-0.1 mm (0-0.004 in.) |
|
6. | If the clearance is more than the standard, select a new 72 mm shim from the following table. If the clearance measured in step 5 is within the standard, go to 9.
72 mm Shim | Part Number | Thickness |
---|
A | 41441-PL3-A000 | 1.0 mm (0.0394 in.) | B | 41442-PL3-A000 | 1.1 mm (0.0433 in.) | C | 41443-PL3-A000 | 1.2 mm (0.0472 in.) | D | 41444-PL3-A000 | 1.3 mm (0.0512 in.) | E | 41445-PL3-A000 | 1.4 mm (0.0551 in.) | F | 41446-PL3-A000 | 1.5 mm (0.0591 in.) | G | 41447-PL3-A000 | 1.6 mm (0.0630 in.) | H | 41448-PL3-A000 | 1.7 mm (0.0669 in.) | J | 41449-PL3-A000 | 1.8 mm (0.0709 in.) | K | 41450-PL3-A000 | 1.05 mm (0.0413 in.) | L | 41451-PL3-A000 | 1.15 mm (0.0453 in.) | M | 41452-PL3-A000 | 1.25 mm (0.0492 in.) | N | 41453-PL3-A000 | 1.35 mm (0.0531 in.) | P | 41454-PL3-A000 | 1.45 mm (0.0571 in.) | Q | 41455-PL3-A000 | 1.55 mm (0.0610 in.) | R | 41456-PL3-A000 | 1.65 mm (0.0650 in.) | S | 41457-PL3-A000 | 1.75 mm (0.0689 in.) |
|
7. | Remove the bolts and transmission housing.
|
8. | Replace the thrust shim selected in step 6, then recheck the clearance.
|
9. | Reinstall the transmission.
|
Honda Fit/Jazz 02-05 Workshop Manual
Back to all Manuals