Honda Fit/Jazz - Master Cylinder Removal/Installation
Master Cylinder Removal/Installation
NOTE: Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
1. | On vehicle's with M/T; remove the clutch reservoir bracket (A), and move it aside. Do not disconnect the clutch line from the reservoir.
|
2. | Remove the reservoir cap and brake fluid from the master cylinder reservoir.
|
3. | Remove the brake fluid level sensor connector (A).
|
4. | Disconnect the brake lines (B) from the master cylinder (C). To prevent spills, cover the hose joints with rags or shop towels.
|
5. | Remove the master cylinder mounting nuts (D) and washers.
|
6. | Remove the master cylinder from the brake booster (E). Be careful not to bend or damage the brake lines when removing the master cylinder.
|
7. | Remove the rod seal (F) from the brake booster.
|
Honda Fit/Jazz 02-05 Workshop Manual
Back to all Manuals