Honda Fit/Jazz - Rear Seat Cushion Disassembly/Reassembly
Rear Seat Cushion Disassembly/Reassembly
NOTE:
- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- The left seat cushion is shown, the right seat cushion is similar.
Remove the rear seat cushion.
2. | Remove the screws, remove the foot cover (A) while pulling both pin portions (B) outward.
|
3. | Remove the under cover cap (A).
|
4. | Remove all of the screws and the net set trim (A). Release the edge of the seat-back cover (B) all the way around from the under cover (C).
|
5. | Remove the under cover (A).
|
6. | Release the hook strips (A) of the seat cushion cover (B) from the seat cushion frame (C).
|
7. | Remove the screw (A) and detach the clip (B), then remove the recline cover (C).
|
8. | Separate the seat cushion frame (A) and seat cushion cover/pad (B).
|
9. | Remove the foot pipe (A) from the seat cushion frame (B):
-1 | Disconnect the control cable (C). Take care not to bend the cable.
| -2 | Release the push nut (D), then remove the set pins (E).
| -3 | Remove the foot pipe, bushings (F) and cable hook (G).
| -4 | If necessary, remove the spring pins (H).
|
|
10. | Reinstall the seat cushion in the reverse order of disassembly, and note these items:
- To prevent wrinkles in the seat cushion cover, stretch the material evenly over the pad.
- Make sure the control cable is connected securely.
- Replace the push nuts and spring pins you removed with new ones.
|
Honda Fit/Jazz 02-05 Workshop Manual
Back to all Manuals